Hazardous Location Capping Machine

hazardous location capping machines

Hazardous Location Cappers are engineered to meet and or exceed the most demanding of safety requirements and regulations.

All models are based on the framework of the 49PC and 60PC series. When power is applied, the cappers produce continuous rotating and reciprocating motions. Adding START and STOP switches to the basic machine design results in a single-cycle, or cycle on demand capping machine. Most caps can be tightened using STOCK Swan-Matic Cap-Master Machines.

Model

Description

(click to enlarge)

49VSA/60VSA

HAZARDOUS LOCATION CAPPER

The Air operated models of both the 49PC and 60VS provide the ability to cap bottles in hazardous locations or environments. The cycle rate is controlled by increasing or decreasing the air supply, which should be 90 PSI.

Full Description and Information

(click to enlarge)

C400

The C400 series of cappers are HAZARDOUS LOCATION cappers which use air controllers to energize an air clutch and brake system in order to cycle these cappers on and off.

Full Description and Information

(click to enlarge)

C500

The C500 is also a HAZARDOUS LOCATION capper, but is ALL ELECTRIC, using a variable speed electric motor and electric controls.

Full Description and Information

All electric benchtop models are available for 50Hz and 60Hz operation. The following are options which can be added to enhance machine operation and/or performance:

● Spindle reversing feature to facilitate de-capping

● Longer columns for up to 15 inch containers

● Foot switch for hands-free operation

● Stainless steel shaft and clutch assemblies

● Precision torque hysteresis clutch (accurate to 0.1 in-lbs)

● Special machine surface coatings

● Hazardous location motors

● Adjustable height cart

● Corrosion resistant finish